I had originally made this kit for my RV, but it worked so well that I wanted to share it with others. The design has gone through two revisions to get to this point, but I still consider it a work in progress. This kit was created because all the other kits I could find were poorly made, too large or didn’t meet cell/battery manufacture specifications.
📏Enclosure Outer Dimensions (L x H x W) 📐
13 ¼” x 9 ⅝” x 7 ⅛”
This kit is excellent because:
✅ It’s made in Canada 🍁⛄.
✅ It’s made to secure and protect 280aH 3.4volt cells/batteries into a 4s configuration; for larger configurations, multiple enclosures must be purchased.
✅ The enclosure can be grouped and secured together using threaded rods to become easily expandable and modular.
✅ The enclosure can be stacked vertically to allow for mounting in small spaces. Limit stacking to two enclosures high.
✅ The enclosure incorporates side handles for easier movement.
✅ It was designed to secure Grade A cells/batteries and provide a source of slight compression.
⚠ That also means that the installer or owner should be careful to not over-tighten the fasteners. If cells/batteries are bulging caution must be taken as poorer quality Grade B cells/batteries will have difficulty fitting.
✅ It’s made with high-quality 3D printed plastic and designed for strength.
✅ It can be installed in trailers, campers, RV’s(away from heat sources), in most dry locations and other power center solutions.
⚠ Do not install environments that get hotter than 40°C or 104°F or in wet environments.
✅ It comes with pre and post-sale technical support.
⚠ This kit does not come with or include LiFePo4 cells/batteries. Purchaser provides their own.
📃 Purchaser assumes all liability in the event of damage or injury to self, others or property.
🥇If you have any questions feel free to message me via the website.
Pieces in the Kit
1 x Bottom Tray
1 x Top Tray
2 x Side Panels
2 x Top Caps
4 x 1/4″ Steel Threaded Rod
8 x Nuts
8 x Flat Washers
8 x Lock Washers
